Learning a Job in Robot Schedule

 

Follow these steps to learn a job in Robot Schedule:

1. Add ROBOTLIB to the library list.

2. Enter RBTSTRLRN on a command line to put Robot Schedule into learn mode.

3. Go into the application and take the normal steps to run the job. When the application uses the submit job command (SBMJOB), the Robot Schedule Initial Job Setup panel displays. Enter the run times and select the run days for the job.

4. When exiting the Initial Job Setup panel, the RBTCAPTURE command appears (in most cases) to say if the job will run. Press Enter to complete this step.

5. Robot Schedule returns to the application panel found before the Initial Job Setup panel displayed.

6. Enter RBTENDLRN on a command line to end the learning session.