Posted Fri, 12 Jun 2020 00:58:07 GMT by

Whats the best way to make a network utilization graph with intermapper? I can access the per port snmp data from my cisco network switches and computer interfaces but I can only make latency graphs

Thank you

Posted Fri, 12 Jun 2020 04:15:00 GMT by

Hi Eric,

I would recommend the Flows feature if you haven't tried that yet. Let me know if you need a temporary license to test the feature out or if you have any questions.

https://community.helpsystems.com/knowledge-base/intermapper/flows/intro-to-intermapper-flows-faqs/

I also know some customers will export the chat data database and create their own reports off the data.

Thanks,

Steve Vold

Intermapper Support Rep

 

Posted Sat, 13 Jun 2020 09:49:05 GMT by

Hi Steve thanks for your response . I do have a Flows License but to enable flows on my cisco switches I dont see an easy example on how to enable *flow* so if you have an example on how to configure a cisco 9300 or 4500 that would be great. But I did find something which I thought would be much simpler .

What about the intermapper "interface status" tab .... this is exactly what I want but I just don't know how to get to it . Here is the web page that describes it but Im  not clear at all on how or what was clicked on to get it. Here is the page:

https://www.networkmanagementsoftware.com/intermapper-network-monitoring-review/

in the middle of the page you see the "Intermapper Interface Status" graphic .

If you can show me (in detail)  how to get this tab, I think this would solve my problem.

 

 

Posted Mon, 15 Jun 2020 20:47:10 GMT by

Do you have a few minutes to look at it over my gotomeeting room? You can email me at [email protected]

Thanks,

Steve

You must be signed in to post in this forum.